SmartStart Z-Wave Network Add
Swidget's Z-Wave inserts are SmartStart enabled products.
SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code found on the insert with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will be added automatically within 10 minutes of being switched on in the network vicinity.
The QR code and PIN code will be found on a label on the insert and will appear similar to the following:
The full DSK and underlined PIN Code portion will look like this:
Note: that the first 5 digits are also known as “the pin code”. The pin code may be utilized by some controllers as an alternative to QR code scanning.