Factory Default Local Reset
To reset a Swidget Z-Wave Insert to factory defaults, press and hold the push button on the insert for 10 to 15 seconds, until the LED turns RED, and then release.
While you hold the button, the LED shows where you are:
- After 1 second: GREEN. Releasing now turns the load on or off.
- After 5 seconds: BLUE. Releasing now starts network add/remove.
- After 10 seconds: RED. Releasing now triggers the Factory Default Local Reset.
- After 15 seconds: the LED turns off. Releasing now does nothing, and the LED returns to its default state.
When the reset is in progress, the LED cycles red, green, blue until it finishes, then returns to its default state.
NOTE: The local reset procedure should only be used when the original controller is inoperable or has been replaced, or if Network Add or Network Remove operations have failed after a few attempts.
Resetting to factory default settings will reset the insert's network parameters to the default removed state, reset configuration parameters to their factory default states, and delete all association group entries.
Comments
0 comments
Please sign in to leave a comment.