Removing the Insert from the Z-Wave Network Manually

1. Follow network remove steps for your Z-Wave controller/hub.
2. Lightly press the push button on the SZWUC Insert and hold for approximately 5-6 seconds until the LED illuminates solid blue, then release the button. The LED will flash blue to indicate remove mode is enabled.
3. The SZWUC Insert will remain in remove mode for up to 30 seconds. If the device is successfully removed from the Z-Wave network, the LED will be solid blue for 5 seconds then return to the normal operational state. If the device fails to be successfully removed from the network after 30 seconds, the red LED will flash for 3 seconds. If necessary, consult your Z-Wave controller/hub manual and re-try.
4. Please see Factory Default Local Reset section on how to perform a local device reset if multiple attempts fail.