How to add a Swidget Z-Wave insert to Home Assistant. You need Home Assistant with the Z-Wave integration (Z-Wave JS, or the Z-Wave JS UI add-on) and a Z-Wave controller it supports. Setting those up is covered by Home Assistant's Z-Wave documentation.
With the QR code (SmartStart)
- Go to Settings, Devices & services, Z-Wave, and choose Add device.
- Scan the QR code on the insert's label. If you can't use the camera, choose More options and enter the code instead.
- Plug the insert into its Swidget host and turn the circuit on. Home Assistant adds it when it powers up.
With the button
- Plug the insert into its Swidget host and turn the circuit on.
- Go to Settings, Devices & services, Z-Wave, choose Add device, then More options and the option to add a device without a QR code.
- Within 30 seconds, hold the insert's button for 5 to 10 seconds, until the LED turns blue, and let go.
- When Home Assistant asks for a PIN, enter the first five digits of the DSK printed on the insert's label.
The insert shows up as a new device, usually named after its node number. Rename it and set its area from the device page.
Z-Wave Long Range (US and Canada) needs firmware 2.0 and a Long Range QR code: see the Long Range section of Updating a Swidget Z-Wave Insert to Firmware 2.0 (Home Assistant).
The insert's button does different things depending on how long you hold it, and the LED shows which one you will get when you let go: green (1 to 5 seconds) switches the load, blue (5 to 10 seconds) adds it to or removes it from a network, red (10 to 15 seconds) is a factory reset. More: The button in the Technical Reference.
Settings, association groups and parameters: Swidget Z-Wave Inserts: Technical Reference. Questions: email support@swidget.com or use the contact form at swidget.com.
Comments
0 comments
Please sign in to leave a comment.