Use these steps with any Z-Wave hub to remove (exclude) a Swidget Z-Wave insert from its network, for example before moving it to another hub or another host.
- Put your hub in remove (exclusion) mode, following its instructions.
- Hold the insert's button for 5 to 10 seconds, until the LED turns blue, and let go.
- Check that the hub shows the insert as removed.
Removing takes the insert out of the network; set up its associations and scenes again when you add it back.
The hub no longer exists, or removal keeps failing? Factory reset the insert instead. Then delete the old device from the hub by hand if it still lists it.
The insert's button does different things depending on how long you hold it, and the LED shows which one you will get when you let go: green (1 to 5 seconds) switches the load, blue (5 to 10 seconds) adds it to or removes it from a network, red (10 to 15 seconds) is a factory reset. More: The button in the Technical Reference.
Settings, association groups and parameters: Swidget Z-Wave Inserts: Technical Reference. Questions: email support@swidget.com or use the contact form at swidget.com.
Comments
0 comments
Please sign in to leave a comment.