How to add a Swidget Z-Wave insert to a SmartThings or Aeotec Smart Home Hub. For the hub side, see Aeotec's guide.
- Enrol the Swidget Edge Driver on your hub: open this invitation and sign in to your SmartThings account.
- Plug the insert into its Swidget host and turn the circuit on.
- In the SmartThings app, select the plus sign (+), then Scan nearby.
- Hold the insert's button for 5 to 10 seconds, until the LED turns blue, and let go. SmartThings finds the insert; select Setup.
- When asked, enter the first five digits of the DSK printed on the insert's label (it is also on the security card in the box).
Setup takes a few minutes, after which you can control the insert from SmartThings.
Firmware updates: SmartThings can't install firmware on Swidget inserts. To update, see Updating Z-Wave Insert Firmware Using a Z-Wave USB Stick.
The insert's button does different things depending on how long you hold it, and the LED shows which one you will get when you let go: green (1 to 5 seconds) switches the load, blue (5 to 10 seconds) adds it to or removes it from a network, red (10 to 15 seconds) is a factory reset. More: The button in the Technical Reference.
Settings, association groups and parameters: Swidget Z-Wave Inserts: Technical Reference. Questions: email support@swidget.com or use the contact form at swidget.com.
Comments
0 comments
Please sign in to leave a comment.