Use these steps with any Z-Wave hub, if it doesn't add the insert by scanning its QR code. Hub-specific steps: Home Assistant, Hubitat, SmartThings.
Before you start: if the insert goes in an outlet, unplug anything from both receptacles; in a switch or dimmer, turn the load off. After the insert has joined, give it a minute before relying on its power readings.
- Put your hub in add (inclusion) mode, following its instructions.
- Hold the insert's button for 5 to 10 seconds, until the LED turns blue, and let go.
- If your hub asks for a PIN or DSK, enter the first five digits of the DSK printed on the insert's label.
- Check that the hub shows the new device.
It won't join? Make sure it isn't still in another network: remove it first (Removing the Insert from the Z-Wave Network Manually). If it still fails after a few tries, factory reset the insert and try again.
Z-Wave Long Range (US and Canada) needs firmware 2.0 and a Long Range QR code: see the Long Range section of Updating a Swidget Z-Wave Insert to Firmware 2.0 (Home Assistant).
The insert's button does different things depending on how long you hold it, and the LED shows which one you will get when you let go: green (1 to 5 seconds) switches the load, blue (5 to 10 seconds) adds it to or removes it from a network, red (10 to 15 seconds) is a factory reset. More: The button in the Technical Reference.
Settings, association groups and parameters: Swidget Z-Wave Inserts: Technical Reference. Questions: email support@swidget.com or use the contact form at swidget.com.
Comments
0 comments
Please sign in to leave a comment.